Split Tone Operation - Yaesu VX-3R Operating Manual

CTCSS/DCS/EPCS B
13. Press and hold the [ HM/RV ] key for one second to delete all data after the current
position that may have previously been stored in the User Beep.
14. When you have programmed User Beep, press the [ TXPO ] key momentarily to con-
firm the User Beep.
You may check your work by monitoring the programmed User Beep. To do
this, repeat steps 1 - 4 above, then press the [F/W] key.
The VX-3R can be operated in a Split Tone configuration via the Set mode.
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 81: SQSPLT
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select "ON
feature).
5. Press the PTT switch momentarily to save the new setting and exit to normal opera-
tion.
When the Split Tone feature is activated, you can see the following additional parameters
after the "MESSAGE MESSAGE" parameter while selecting the Set Mode Item 79: SQ TYP
MESSAGE MESSAGE
MESSAGE
D CODE: DCS Encode only
D CODE D CODE
D CODE D CODE
(the "
Encodes a CTCSS Tone and Decodes a DCS code
T DCS T DCS
T DCS T DCS: T DCS
(the " " icon will blink and the "
D TONE: Encodes a DCS code and Decodes a CTCSS Tone
D TONE D TONE D TONE D TONE
(the "
Select the desired operating mode, from the selections shown above, within Set Mode Item
79: SQ TYP
SQ TYP. SQ TYP SQ TYP
SQ TYP
VX-3R O
PERATING
CTCSS/DCS/EPCS O
S T
PLIT ONE
ON" (to enable the Split Tone
ON ON
ON
" icon will blink during operation)
" icon will appear and the "
M
ANUAL
O
ELL PERATION
O
PERATION
SQSPLT SQSPLT. SQSPLT
SQSPLT
" icon will appear during operation)
" icon will blink during operation)
PERATION
SQ TYP: SQ TYP SQ TYP
SQ TYP
39