Adjusting The Keypad Beeper Volume Level - Yaesu VX-3R Operating Manual

A
DJUSTING THE
A keypad beeper provides useful audible feed back whenever a keypad is pressed. The
keypad beeper level changes according to the receiver audio volume level setting. How-
ever, you may adjust the volume balance between the receiving audio and keypad beeper
via Set Mode Item 13: BP LVL
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 13: BP LVL
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Item.
4. Rotate the DIAL knob to select the desired level.
5. When you have made your selection, press the PTT switch to
save the new setting and return to normal operation.
Additionally, if you want to turn the beep off:
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 14: BP SEL
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Item.
4. Rotate the DIAL knob to change the setting to "OFF
5. Press the PTT switch to save the new setting and return to nor-
mal operation.
6. If you wish to re-enable the Beeper, just repeat the above procedure, rotating the DIAL
knob to select "KEY
KEY: The beeper sounds when you press any key.
KEY KEY
KEY KEY
KY+SCN: The beeper sounds when you press a key or when the scanner stops.
KY+SCN KY+SCN KY+SCN KY+SCN
VX-3R O
PERATING
K
EYPAD
BP LVL BP LVL. BP LVL
BP LVL
KEY" or "KY+SCN KY+SCN" in step "4" above.
KEY KEY KY+SCN KY+SCN
KEY KY+SCN
M
ANUAL
A
DVANCED
B V
EEPER OLUME
BP LVL BP LVL. BP LVL BP LVL
BP SEL BP SEL
BP SEL. BP SEL
OFF OFF OFF OFF".
O
PERATION
L
EVEL
19