Yaesu VX-3R Operating Manual page 107

S M I F
ET ODE TEM UNCTION
51 [ MRFSTP ]
Selects the channel step for the fast channel selection mode
while in the Memory Recall mode.
52 [ MRNAME ]
Stores "Alpha-Numeric" tags for the Memory channels.
53 [ MRPTCT ]
Enables/Disables the Memory Write Protector.
54 [ MRSKIP ]
Selects the Memory Scan, channel-selection mode.
55 [ MSG.LST ]
Programming a Member List for the Message feature.
56 [ MSG.REG ]
Selects your Personal ID for the Message feature.
57 [ MSG.SEL ]
Programming a Message for the Message feature.
58 [ ON TMR ]
Set the On Timer Time.
59 [ OPN.MSG ]
Selects the Opening Message that appears when the radio is
powered on.
60 [ PAG.ABK ]
Enables/Disables the Answer Back function of the Enhanced
CTCSS Paging & Code Squelch.
61 [ PAG.CDR ]
Sets the Receiver Pager Code for the Enhanced CTCSS Pag-
ing & Code Squelch.
62 [ PAG.CDT ]
Sets the Transmitting Pager Code for the Enhanced CTCSS
Paging & Code Squelch.
63 [ PR FRQ ]
Program the CTCSS Tone frequency for the User programmed
Reverse CTCSS Decoder.
64 [ PRI.RVT ]
Enables/Disables the Priority Revert feature.
65 [ PRI.TMR ]
Selects the time between the Priority (Dual Watch) channel
checks, when the feature is active.
66 [ PSWD ]
Programs and activates the Password feature.
67 [ PTT.DLY ]
Selects the time delay before the carrier is transmitted, when
the PTT switch is pressed.
68 [ RPT ]
Sets the Repeater Shift Direction.
69 [ RPT.SFT ]
Sets the magnitude of the repeater Shift.
70 [ RX MD ]
Selects the Receiving mode.
71 [ S SRCH ]
Selects the Smart Search Sweep mode.
72 [ SAVERX ]
Selects the Receive-mode Battery Saver interval ("sleep" ra-
tio)
73 [ SAVETX ]
Enables/Disables the Transmitter Battery Saver.
74 [ SCN.LMP ]
Enables/Disables the Scan lamp (while scanning is paused)
75 [ SCN.RSM ]
Selects the Scan Resume mode.
76 [ SCN.STR ]
Select the Scan Re-start Delay time.
77 [ SP OUT ]
Enables/Disables the FM Broadcast audio output to the inter-
nal speaker when using the earphone antenna.
78 [ SQ LVL ]
Sets the Squelch threshold level.
79 [ SQ TYP ]
Selects the Sub Audible Squelch Type.
80 [ SQSMTR ]
Adjusts the Squelch threshold to the S-meter level.
81 [ SQSPLT ]
Enables/Disables split CTCSS/DCS coding.
82 [ STEP ]
Setting the Dial frequency steps.
83 [ STEREO ]
Enables/Disables stereo out put, while receiving the FM Broad-
cast band.
84 [ SUB-RX ]
Sets the time before Broadcast audio is resumed after the
amateur band signal drops, when the SUB-RX operation is
activated.
85 [ TEMP ]
Indicates the current temperature inside the transceiver's case
and selects the measurement units ("°F" or "°C") for the tem-
perature sensor.
86 [ TN FRQ ]
Setting of the CTCSS Tone Frequency.
87 [ TOT ]
Setting of the TOT time
88 [ TS MUT ]
Enables/Disables the receiver audio output while the Tone
Search Scanner is activated.
89 [ TS SPD ]
Selects the Tone Search Scanner speed.
90 [ VFO MD ]
Selects or disables the VFO band edge limiting for the current
band.
91 [ VFO.SKP ]
Set My Band.
92 [ VOL MD ]
Select the DIAL knob function.
93 [ WAKEUP ]
Setting of the Wakeup feature.
94 [ WX ALT ]
Enables/Disables the NOAA Weather Alert Feature.
VX-3R O
PERATING
M
ANUAL
( M
S
ET ENU
( D
A V
VAILABLE ALUES EFAULT
10CH / 20CH / 50CH / 100CH
---
ON / OFF
OFF / SKIP / ONLY
---
---
---
OFF / 00H.10M(00:10) - 24H.00M(24:00)
(10 minutes/step)
OFF / DC / MSG
ON / OFF
---
---
300Hz - 3000Hz (1000 Hz/step)
(1600Hz)
ON / OFF
0.1 - 0.9S (0.1S/step) or 1.0S - 10.0S
(0.5S/step) (5.0S)
---
OFF / 20MS / 50MS / 100MS / 200MS
SIMP / -RPT / +RPT
(Depends on the operating band and
transceiver viersion)
0.00 - 150.00 MHz (50 kHz/step)
(Depends on the operating band and
transceiver viersion)
AUTO / N-FM / AM / W-FM
SINGLE / CONT
0.2S - 0.9S (0.1S/step) or 1.0S - 10.0S
(0.5S/step)
ON / OFF
ON / OFF
2SEC - 10SEC / BUSY / HOLD (5SEC)
0.1-0.4S (0.1S/step) or 1.0S - 10.0S
(0.5S/step) (2.0SEC)
AUTO / SPKR
LVL 0 - LVL 15 (AM and N-FM) (LVL 1),
LVL 0 - LVL 8 (LVL 2)
(Wide FM and AM Broadcast)
OFF / TONE / TSQL / DCS / RV TN /
PR FRQ / PAGER / MESSAGE
OFF / LVL 1 - LVL 8
ON / OFF
AUTO / 5 / 8.33 / 9 / 10 / 12.5 / 15 / 20 /
25 / 50 / 100 kHz
STEREO / MONO
OFF / TRX 1S - TRX 10S (1S/step) /
HOLD / TX 1S - TX 10S (1S/step)
---
50 standard CTCSS tones (100Hz)
OFF / 0.5M - 10.0M (0.5M/step) (3.0M)
ON / OFF
SLOW (1.25 tone/sec) /
FAST (2.5 tone/sec)
ALL / BAND
ON / OFF
NORMAL / AUT.BCK
OFF / 5SEC - 60SEC(5SEC/step) / EAI
OFF / ON
) M
ODE
)
: B I
OLD TARIC
105