Yaesu FT-950 Operating Manual page 27

Block Diagram Display
ANT ( 1, 2 ) :
Indicates the antenna selected by the front panel [ ANT
1-2 ] button.
ATT ( OFF, –6 dB, –12 dB, –18 dB ) :
Indicates the attenuation level, selected by the front
panel [ ATT ] button.
FLT ( μ-TUNE, THRU ) :
Indicates when the optional μ-TUNE RF filter is se-
lected by the front panel [ μ-TUNE ] button.
A :
DVICE
The icon will not appear unless the optional μ-TUNE
unit is connected.
IPO ( AMP 1, AMP 2, ON ) :
Indicates which front end RF amplifier is selected by
the front panel [ IPO ] button.
R.FLT ( AUTO, 3 kHz, 6 kHz, 15 kHz ) :
Indicates the receiver IF Roofing Filter, which is se-
lected by the front panel [ R.FLT ] button.
AGC ( AUTO, FAST, MID, SLOW ) :
Indicates the AGC decay time setting, selected by the
front panel [ AGC ] switch.
FT-950 O
PERATING
D
ISPLAY
M
ANUAL
I
NDICATIONS ( C
DNR
This indicator appears whenever the Digital Noise Re-
duction feature is activated.
DNF
This indicator appears whenever the Digital Notch Fil-
ter is activated.
CONTOUR
The peak position of the CONTOUR Filter is graphi-
cally depicted here when the CONTOUR Filter is acti-
vated.
NOTCH
The null position of the IF Notch Filter is graphically
depicted here when the IF Notch Filter is activated.
WIDTH
Indicates the bandwidth setting of the DSP IF filter.
SHIFT
Graphically indicates the peak position of the DSP IF
filter.
)
ENTER
Page 25