Table of Contents
Advertisement
S
PECTRUM
U
SING THE
LBWS (Limited Band Width Sweep) is a function that sweeps a limited segment of the Spectrum Scope span
without changing the span (bandwidth). As the sweep segment becomes narrower, the speed becomes faster,
and the accuracy and resolution become enhanced.
The bandwidth can be set to 50 %, 30 %, or 10 % of the full span. The sweep speed will increase as follows:
50 %: about 2 times faster, 30 %: about 3 times faster, 10 %: about 10 times faster
1. By pressing the [ F7 ]( CTR/FIX ) key repeatedly, the
CTR mode and the FIX mode will be toggled alter-
nately.
2. By pressing the [ F2 ]( SPAN ) key, you can set the
bandwidth of the span viewed using the Spectrum
Scope.
By pressing the [ F2 ]( SPAN ) key, the span will
change as follows.
25 kHz
50 kHz
500 kHz
1000 kHz
......
3. Press the [ F3 ]( ATT ) key to set the desired attenu-
ation value.
By pressing the [ F3 ]( ATT ) key, the attenuation will
change as follows.
0 dB
10 dB
20 dB
4. By pressing the [ F6 ]( LBWS ) key, the LBWS seg-
ment width will change as follows.
LBWS-1 ( 50% )
NORMAL
LBWS-2 ( 30% )
LBWS-3 ( 10% )
5. Press the [ F4 ]( A/B ) key to select the Main (VFO-
A) or Sub (VFO-B) VFO.
Advice:Please note that the LBWS feature can not
be used in the FIX mode. Please use LBWS only in
the CTR mode.
While using LBWS, it is not possible to switch to the
dual display mode.
Note:The QMB marker will not appear on the screen
while LBWS is engaged.
Page 16
S
COPE
LBWS ( L
IMITED
100 kHz
250 kHz
2500 kHz
25 kHz
0 dB ......
NORMAL ......
B
W
S
AND
IDTH
WEEP
FT
9000 TFT O
DX
) F
UNCTION
"LBWS" Select
"LBWS" Select
M
PERATION
ANUAL
Advertisement
Table of Contents
