Download Print this page

APS iBoard IB-131C Manual

Black powder coated 5in running boards nerf bars side steps compatible with chevy tahoe gmc yukon 2000-2020 4dr

Advertisement

Quick Links

®
iBoard
READ INSTRUCTIONS CAREFULLY BEFORE
START ING INSTALLATION. REMOVE CONTENTS
FROM BOX AND VERIFY ALL PARTS ARE PRE-
SENT. ASSISTANCE IS RECOMMENDED.
*BODY FRAME MOUNT
*NO DRILLING REQUIRED
PART LIST
Driver Side Step Bar
Driver Front Mount-
ing Bracket (DFM)
Driver/Passenger Center
Mounting Bracket (DCM/
PCM)
Driver Rear Mount-
ing Bracket (DRM)
Note: Driver Center Mounting Bracket & Passenger Center Mounting Bracket Are Universal
iBoard
by APS
Customer Support: info@iboardauto.com
®
Fastener Size
Tightening Torque (ft-lbs)
6mm
8mm
10mm
12mm
14mm
Front
Passenger Front
Mounting Bracket
Passenger Rear
Mounting Bracket
1
PART#: IB-131C&H
Required
6-7
16-18
31-32
56-58
92-94
Passenger Side Step Bar
(PFM)
(DCM/PCM)
(PRM)
Rev. 20230301
X
X
X

Advertisement

loading
Need help?

Need help?

Do you have a question about the iBoard IB-131C and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for APS iBoard IB-131C

  • Page 1 ® ® iBoard by APS PART#: IB-131C&H Fastener Size Tightening Torque (ft-lbs) Required READ INSTRUCTIONS CAREFULLY BEFORE START ING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRE- SENT. ASSISTANCE IS RECOMMENDED. 16-18 √ 10mm 31-32 12mm 56-58 √...
  • Page 2 iBoard ® Hardware Package A (For Bracket Installation) Item Description Item Description M12Χ1.75-120mm Hex Bolts M12 Lock Washer M12 Large Flat Washers Hardware Package B (For Stainless Steel Step Bar Installation) Item Description Item Description M8X1.25-35mm Carriage Bolts M8 Nylon Lock Nuts M8 Large Flat Washers Sliders (Packed with Step Bars) Customer Support: info@iboardauto.com...
  • Page 3 iBoard ® STEP 1 Factory Body Mount Bolt Start the installation under the Driver side of the vehicle. Re- move the front and rear body mount hex bolts. Do not remove the rubber bushings, (Fig 1). STEP 2 Hang the driver side front / center and rear Mounting Brackets to the body mounts using the factory hex bolts.
  • Page 4 iBoard ® STEP 3 Attention Once all (3) Driver side mounting brackets are installed, then Do periodic inspections to the installation to make sure proceed to the Step Bar installation. (Figs 3 & 4) that all hardware is secure and tight. (1) Select (1) Slider and (2) M8X1.25-35mm Carriage Bolts;...

This manual is also suitable for:

Iboard ib-131hIboard ib-c5131w