Leviton T5320-E Manual

E N G L I S H
TO INSTALL:
DUPLEX RECEPTACLE
Rated: 15A-125V
WARNING:
TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH
APPROPRIATE ELECTRICAL CODES AND REGULATIONS.
WARNING:
IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS,
CONSULT AN ELECTRICIAN.
FOR SEPARATE FEED CONVERSION ONLY: Our outlet is provided with a break-
off fin located between the two brass te rminal screws. If you want to have the top
outlet and the bottom outlet controlled by two different hot wires (two circuits), remove the break-off fin before wiring.With
needlenose pliers, bend fin back and forth until it breaks off.
WARNING:
1. TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT
THE POWER IS OFF BEFORE WIRING!
2. Remove insulation per strip gauge on device [about 5/8" (1.6 cm)].
3. Connect wires per WIRING DIAGRAM as follows:
To Side Wire: Loop wires clockwise 3/4 turn around terminal screws. BLACK (hot) wire to BRASS screw, WHITE (neutral)
wire to SILVER screw, GREEN or BARE (ground) wire to GREEN screw. Firmly tighten screws over wire loops. Terminal
screws accept up to #12 AWG copper or copper clad wire.
To Quickwire ™: Insert straight #14 AWG solid copper wires into round Quickwire™ holes. Quickwire™ terminals accept
#14 AWG solid copper wires ONLY! For circuits with #12 AWG solid copper or copper clad wires, use terminal screws
instead. If the receptacle must be replaced or rewired after Quickwiring, gently press the tip of a small screwdriver in the
release slot and back the wire out gradually.
4. Mount device using long mounting screws. Attach wallplate (not included).
5. Restore power at circuit breaker or fuse. Installation is complete.
Neutral (White)
Neutre (Blanc)
Neutro (Blanco)
Green Grounding Screw
VIs de mise á la terre (vert)
Tornillo verde para
conexión a tierra
Hot (Black)
Sous tension (Noir)
Fase (Negro)
Protected under U.S. patents pending
Break-off Fin
L'ailette détachable
Aleta Rompible