Kuryakyn 1832 Installation Instructions

PASSENGER DRINK HOLDER, RIGHT SIDE
Thank You For Choosing Küryakyn!
Protect yourself and others from potential injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices
regarding the installation, use, and care of this product.
ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:
1 Passenger Drink Holder Assembly
1 Bracket
1 Hardware Kit containing
1
1
1
1
1
1
1
YOU WILL ALSO NEED:
Set of hex wrenches, warm, soapy water and a clean rag
STEP 1 Read and understand all steps in the instructions before starting the installation. Park the motorcycle on a hard, level surface and turn
IGN OFF.
STEP 2 Refer to PIC 1. Open the trunk lid; locate the screw shown in PIC 1.
STEP 3 Remove and discard the screw.
STEP 4 Refer to PIC 1. Using warm soapy water and a clean rag, remove all dirt and
debris from the installation area; allow the area to dry completely.
STEP 5 Refer to PIC 2. Locate and align the included Standoff over the hole.
1832-11MC-0216
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN
RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
This indication alerts you to the fact that ignoring the contents described herein may negatively affect product per-
formance and functionality or damage the product itself or the product to which it is being attached.
Standoff
1/4" Flat Washer
1/4" Lock Washer
Thumb Nut
M6 X 1.0 X 30MM Button Socket Cap Screw
M6 Flat Washer
M6 Lock Washer
These installation instructions contain important information. Ensure that the end user receives this copy and is
aware of its importance for future use.
Avoid damage to the motorcycle. Protect painted surfac-
es with a soft cloth or blanket.
PIC 1
CLEAN + DRY
PIC 2
1832
BRAKE-SIDE (RIGHT)
Page 1