Download Print this page

ANCEL BST500 Operating Manual

Battery system tester

Advertisement

Quick Links

B ATTERY SYSTEM TESTER
B ST500
OPERATING MA NUA L

Advertisement

loading
Need help?

Need help?

Do you have a question about the BST500 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ANCEL BST500

  • Page 1 B ATTERY SYSTEM TESTER B ST500 OPERATING MA NUA L...
  • Page 11: Charging System Test

    ( 3)After selecting to get access to the below screen (4)After operating as step (3) , press <ENTER> to display the maximum load system test screen as the picture below: As can be seen in the picture current test voltage is 12.86V, standard voltage is 12.80V,(for 24V system, standard voltage is 25.60V), the lowest voltage is 12.30V.
  • Page 12 5-5-2 Procedure of operation (1) When the engine is working, connect the red clamp to the positive polar of the battery, and the black one to the negative polar. Make sure they are well connected in order to avoid affected result. ( 2)Press <▲><▼>to select charging system test as the picture below: ( 3)After selecting to get access to the below screen (4)After operating as step (3) , press <ENTER>...
  • Page 13 is over 30.00V), please check the voltage regulator. ★ If the voltage is lower than 13.30V,(for 24V system, the reading is under 26.60V), please check the connections, wires and the engine. Data Reference Table (12V system) Status Voltage Condition normal >13.5 Headlights and general...
  • Page 14: What Is The Measurement Principle Of This Tester

    (2) Then set the date and report number. If not need it , press <ESC> to skip. (3) Press <ENTER> or <ESC> to print the report. (4) After printing the report, the tester is set back to the step(3) in the 5-2 storage battery test.