curt 11667 Manual

11667
4/19/2010
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM QTY PART NUMBER
1 6 3/8 - 16 x 1 1/4 HEX BOLT
2 4 3/8" FENDER WASHER
3 10 HFN3816 HEX FLANGE NUT
4 2 3_8 FISHWIRE 3/8" FISHWIRE
5 4 CM-SP18 .250 x 1.00 x 2.00" SQUARE HOLE SPACER
6 4 3/8-16 x 1 1/2 CARRIAGE BOLT
HITCH WEIGHT: 11 LBS.
INSTALL TIME
PROFESSIONAL: 40 MINUTES
NOVICE (DIY): 80 MINUTES
INSTALL NOTES:
- CLEAR TRUNK
- DRILLING REQUIRED
- SILICONE SEAL HARDWARE
INSTALLATION STEPS
1. This hitch mounts to the bottom of the bumper beam and to the rearward section fo the trunk pan. Clear trunk
of contents.
2. Remove plastic snaps holding bumper fascia to bumper. Lift hitch into position and align it with vehicle's
centerline.Using hitch as a template, drill bumper beam for 3/8" fasteners and fishwire fasteners as shown.
Fishwire access is from ends of bumper or installer drilled 1" access holes.
3. Making sure hitch is square and level, use hitch as a template and drill trunk floor for 3/8" fasteners and
install fasteners as shown.
4. Drill bumper mounts for 3/8" fasteners as shown, on outside ears of driver and passenger side frame rails.
Install fasteners as shown.
5. Torque all 3/8" fasteners to 30 lb-ft.
6. Silicone seal hardware installed through trunk floor.
7. Reinstall contents removed from trunk in Step 1.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
217420
94-99 DODGE AND PLYMOUTH NEON
DESCRIPTION
1
2
DRILL HOLES
TRUNK FLOOR
6
5
2,000 LBS. TRAILER WEIGHT &
1-800-798-0813
3
BUMPER
MOUNT
DRILL HOLES
4
200 LBS. TONGUE WEIGHT.
EXISTING FASTENERS BOTH SIDES
( DRIVER SIDE NOT SHOWN)
1
DRILL HOLES (BOTH SIDES)
BUMPER BEAM
INSTALLER MAY DRILL 1" ACCESS
HOLE INTO BUMPER FOR EASE
OF FISHWIRING