Dynacord MP7 Owner's Manual page 40

TANDARD IN TALLATION
Place the needed sound source devices (e.g. CD-Player, turntable) or microphones on a secure even location and,
if necessary, establish mains connections
Connect all the gear to the MP7 (Fig. 2).
Employ cables with stereo phone-type plugs to connect the AM12 to the MONO OUT of the MP7. Set the LINE
IN-control on the AM12 at its center position. This lets you control the AM12's volume setting from the MONO
OUT-control on the MP7.
Set all faders on the MP7 at their minimum position and turn all output controls (e.g. MONO OUT) counterclockwise
as far as possible. Switch on the power of all included components in the following sequence:
1. Sound ource equipment, e.g. CD-Player, turntable, etc.
2. MP7
3. AM12 active monitor
Following thi order when witching on your y tem prevent unplea ant power-on noi e and feedback.
Your PA-system is now ready for operation!
"
(
Fig. 2)