Dynacord MP7 Owner's Manual page 39

TANDARD IN TALLATION
In the following we will explain how to set up a standard PA-system with monitoring facility using the MP7.
The equipment list includes:
1 MP7
2 Hi-range speaker system cabinets, e.g. CP 12-2
2 Bass speaker system cabinets e.g. CP 12-1
2 Loudspeaker pole-mount stands or 2 intermediate poles
2 Speakon cables, 8m
2 Speakon cables, 2m
1 AM12 active monitor system
1 LF-cable with stereo phone plug
Setting up
Look for the most suitable location to set up the loudspeaker systems. Whenever possible, place the bass cabinets
on the floor and the Hi-range cabinets directly on top. However, in doing so, make sure that the hi-range cabinets'
lower edge is in the same height of the audience's heads or above. You can either use intermediate poles between
the bass and Hi-range cabinets or, if this does not provide enough elevation for the speaker systems or there are no
bass cabinets included, use appropriate speaker pole-mount stands.
Compact overall sound is achieved by placing the left and right loudspeakers as far apart from each other as necessary
but as close together as possible.
Make sure that the main speakers are not behind you. Otherwise you will be facing feedback whenever your system
set-up includes microphones or turntables.
Use SPEAKON-type cables to establish connections between the loudspeaker systems and the MP7. Follow the
instructions as shown in figure1. Make sure not to inadvertently reverse connect the left and right channels. The short
SPEAKON-type cables are used to parallel connect Hi-range and Bass cabinets.
(
Fig. 1)
'