AccuEnergy Acuvim II Series User Manual page 17

1.800.561.8187
Figure 2-6 Rear View of Acuvim II Meter
11
The table below specifies the part name and description of the Acuvim II series meter.
Table 2-1 Meter Part Name and Description
Part Name
1) LCD Display
2) Front Casing
3) Key
4) Enclosure
5) DIN rail
6) Voltage Input Terminals
7) Current Input Terminals
8) Power Supply Terminals
9) Communication Terminals
10) Interface
11) Installation Clip
12) Gasket
www.
6
8
9
7
10
Figure 2-7 Rear View of Remote Display
Figure 2-8 Installation Clip
Description
Large bright white backlight LCD display.
Visible portion (for display and control) after mounting onto a panel.
Four keys are used to navigate through the display and configure settings.
The Acuvim II series meter enclosures are made of high strength anti-combustible
engineering plastic.
Used for installation of 35mm rail of the DIN rail meter.
Used for voltage input.
Used for current input.
The Control Power Input.
The RS485 communication port on the meter.
Used for linking the remote display unit and the DIN rail meter.
Used for fixing the meter to the panel.
Rubber gasket inserted between the meter and the cutout to cover up gaps from the
round hole.
.com
Chapter 2: Installation
Unit: mm (inches)
17
V: 3.0 Revised: November 2022
information@itm.com