METHVEN WAIPORI Installation Manual

Flow Rate - (Bath Filler)
The flow restrictor can be changed if the fixed* wall spout is going to be used
as a bath filler. Spout is supplied with a flow restrictor for basin applications.
To change the flow restrictor see instruction below.
Remove flow restricted (green) aerator using the supplied cache key.
Replace with unrestricted (blue) aerator.
* Swivel mounted wall spout is only recommended for use as a bath filler.
Care and Cleaning:
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Periodically the aerator should be removed as shown below and cleaned under running water.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may a°ect y our warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
IS2058
Australia
0800 195 1602
13 14 16
WAIPORI WALL MOUNTED BATH SPOUT
Installation Guide
Technical Specifications:
Operating Pressure:
Min 35kPa, Max 1000kPa. Recommended
35kPa - 500kPa. Recommended installation
of a pressure limiting
valve if supply exceeds 500kPa.
Operating Temperature:
Max 70°C*
AS/NZS 3500 requires all hot water supplies
to any sanitary fitting to be tempered to 50°C
Inlet Connections:
All ½" BSP
* Regional specific regulations apply. Please
refer to your warranty statement at
www.methven.com
UK
ISSUE A
www.methven.com