METHVEN FLEXISPRAY Quick Start Manual

Methven warrants this product against manufacturing defects and that it is suitable for use

under the general operating conditions speciﬁed in this instruction sheet. However, regional

regulations apply and may aﬀect your warranty. Please refer to www.methven.com or call

customer service for full details.

New Zealand

Australia

SINK MIXER

Technical Speciﬁcations:

Operating Pressure:

Min:

kPa/

bar

Max:

kPa/ bar*

Optimum:

kPa/ . bar -

Operating Temperature:

Hot: Max

°C*

Cold: Min °C

Inlet Connections:

All ½" BSP

* Regional speciﬁc regulations apply.

Please refer to your warranty statement

at www.methven.com

ISSUE A

kPa/ bar

Table of Contents

Need help?

Do you have a question about the FLEXISPRAY and is the answer not in the manual?

Page 1 Please refer to your warranty statement at www.methven.com Methven warrants this product against manufacturing defects and that it is suitable for use under the general operating conditions speciﬁed in this instruction sheet. However, regional regulations apply and may aﬀect your warranty. Please refer to www.methven.com or call customer service for full details.
Page 2 ﬁt isolation valves to both the hot and cold supply. General: Installation: • Methven recommends this product is installed by a licensed plumber in compliance with all Cut a single 35mm diameter hole into the mounting surface or use existing hole. relevant regional regulations.