Table of Contents
Advertisement
SC50 SC51 SC53
DO NOT CUT OR SPLICE THE CAMERA'S CABLES. MODIFYING THE UNIT IN ANY WAY WILL VOID THE WARRANTY. DAMAGE FROM
EXPOSURE TO MOISTURE, STATIC DISCHARGE, OR OTHER HARMFUL ENVIRONMENTAL FACTORS IS NOT COVERED BY THE WARRANTY.
Installation Procedures:
1. Ensure that the camera is grounded with the ground strap as shown in the FCC Information.
2. Connect a grounded video cable from the viewing device (monitor, Quad, DVR, modulator, etc.) to the camera's
Video Connector. Adapters, such as BNC to F or RCA, may be used where appropriate.
3. Connect the 12V DC 300mA Power Transformer from an AC outlet to the camera's Power Input Connector.
4. Install Camera Assembly into the Junction Box (not included) and adjust for proper viewing.
5. Snap the dark or clear Lens Cover into the Cover Plate (not included) by pressing all four corners in simultaneously.
6. Attach the Cover Plate to the Junction Box. Silicon or similar sealant may be used as needed.
Camera
Figure 1 - Connecting the camera to a security monitor or standard television. Use the TV's composite RCA Video In
jack and view through its video or line input. The picture will not be available on a channel.
Camera
Figure 2 - Connecting the camera to multiple pieces of video equipment. Every piece except the last must have a
loopback or video output jack.
Camera
Main cable or
antenna
Figure 3 - Connecting the camera to a modulator for whole house distribution and standard television viewing on
the modulated channel. The modulator can also be the last piece of equipment in Figure 2.
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: sales@netmedia.com www.netmedia.com
Video Cable
Sequencer
Modulator
Amplifier
Splitter/
Combiner
Quad.
or
DVR
Distribution
Panel
or Splitter
Monitor
or
Television
Monitor
To Next
or
Device
Television
Television
Television
MAN-VIDJBOX
REV0612A
Advertisement
Table of Contents
