Table of Contents
Advertisement
MM70
Installation Procedures:
1. Remove the End Plate from the modulator assembly and set the channel with the switches as shown in
Figure 1. Choose an unused channel that matches the tuning mode of the televisions. With antenna
tuning, choose a UHF channel from 14-69. With cable tuning, choose a CABLE channel from 70-94 or
100-125. There must be at least one blank channel on either side of the modulated channel to separate
it from any other broadcast, cable, or modulated source. When combining with cable service, be aware
that digital data typically interferes with channels 80-117, even when not subscribed to digital services.
If no channels are available then a filter such as NetMedia's CNF7080 (ch. 70-80) may be necessary.
2. Connect a coax cable from the camera's F connector to the coax from a television or distribution system.
Connect the 12V DC 100mA power supply to an AC outlet.The modulator picture is now available on the
programmed TV channel.
OFF
ON
80 40 20 10
CABLE Channel 125
Figure 1 - Setting the modulated channel with the switches. Valid channels are UHF 14-69, CABLE 70-94, 100-125.
Main cable or
antenna
Figure 2 - Connecting the modulator to an antenna or cable service and distributing to multiple televisions.
Dual LNB
Satellite
Figure 3 - Connecting the modulator to a satellite system and distributing to multiple televisions.
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: sales@netmedia.com www.netmedia.com
Add numbers
switched ON
to set channel.
8
4
2
1
Optional Ch. 70-80 Filter (NM-CNF7080)
when there are no clear cable channels.
OFF
ON
80 40 20 10
UHF Channel 25
Distribution
Panel
or Splitter
Splitter/
Combiner
Satellite
Diplexer
Satellite
Multiswitch
w/Ant input
8
4
2
1
Television
Television
Satellite Reciever
Sat In
Ant In
Television
MAN-MM70
REV0703A
Advertisement
Table of Contents
