Net Media MM73 User Manual page 62

NM-POCLAMP
DO NOT CUT OR SPLICE THE CAMERA'S CABLES. MODIFYING THE UNIT IN ANY WAY WILL VOID THE WARRANTY.
Installation Procedures:
1. Connect a coax cable (RG6 recommended) to the F-connectors of the camera and Video Decoder. Each
Camera/Decoder pair needs a dedicated point-to-point wiring circuit. Do not connect the Camera/Decoder coax to
video distribution equipment! Doing so could damage this product and/or the other attached devices!
2. Connect a video cable from the viewing device (monitor, Quad, DVR, modulator, etc.) to the Decoder's RCA Video Out
Connector. Simple adapters, such as RCA to BNC, may be used where appropriate.
3. Connect the 24V DC 200mA Power Transformer from an AC outlet to the Decoder's Power Input Connector.
4. Mount the Base to the junction box (not included) and adjust the camera assembly for proper viewing. When
satisfied, secure all adjustment points.
Camera
Figure 1 - Connecting the camera to a security monitor or standard television. Use the TV's composite RCA Video In
jack and view through its video or line input. The picture will not be available on a channel.
Camera
Figure 2 - Connecting the camera to multiple pieces of video equipment. Every piece except the last must have a
loopback or video output jack.
Coax Cable
Camera
Main cable or
antenna
Figure 3 - Connecting the camera to a modulator for whole house distribution and standard television viewing on
the modulated channel. The modulator can also be the last piece of equipment in Figure 2.
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: sales@netmedia.com www.netmedia.com
Up to 100 Feet
Coax Cable
Coax Cable
PoC Video Decoder Module
PoC Video Decoder Module
PoC Video Decoder Module
Quad.
Sequencer
or
DVR
Modulator
Amplifier
Splitter/
Combiner
Video Cable
Television
Monitor
or
Television
Distribution
Panel
or Splitter
Television
Television
MAN-POCLAMP
Monitor
or
To Next
Device
REV0703A