Setting Up Your Display; Connecting The Power Cord; Connecting The Antenna; Connecting Catv - BenQ DV3250 User Manual

Setting up Your Display

Connecting the Power Cord

1. Connect the female end of the AC power cord to the AC input on the display.
2. As shown in the diagram, connect the male end to a wall power outlet.
• The figure above shows the power cord connection. The shape of the physical power cord plug
and socket will differ depending on the location where you purchased the display.
• This product must be operated only from the type of power source indicated on the marking
label (AC 100~240V 50/60 Hz).
• If the display will not be used for a long period of time, it should be unplugged from the wall
outlet.

Connecting the Antenna

Connecting CATV

Your DV3250 LCD Display has an internal 75 ohm coaxial cable connector, so antennal hook-up
is very easy.When connecting a 75-ohm coaxial cable, secure it firmly to the antenna connector.
Some cable TV companies provide "pay per view" programming. Since the signal for these paid
channels is encoded, most cable TV companies provide their own tuners/ decoders. You must
install a tuner/ decoder to be able to view locked encoded programming. If you require special
instructions on how to install cable service, please contact your cable TV provider. The tuner/
decoder provided by your cable TV company can be used according to the following
instructions.
You must have an RF switch with two inputs (A and B) (not supplied).
The "A" input on the RF switch (not supplied) allows you to use the display's CH /
to view unlocked channels. The "B" input on the RF switch (not supplied) allows you to use the
channel selection button on your cable box to view locked encoded programming via the tuner/
decoder.
Power Cord
Setting up Your Display
Power outlet
buttons
7