1. Manuals
  2. Brands
  3. Mars Manuals
  4. Heater
  5. HV2 Series
  6. Manual

Mars HV2 Series Manual

Industrial air curtain submittal package
Hide thumbs Also See for HV2 Series:

Advertisement

Table of Contents

HV2 Submittal Package
HV2 Indirect Gas Fired
Project Name
P.O.#
S.Q.
Company
Print Name
Signature
Date
(Electronic Signature Preferred)
NOTE: Mars Air Systems, LLC reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for
previously purchased equipment.
14716 S. BROADWAY, GARDENA, CA 90248 ● Ph: (310)532-1555 Fax: (310)-532-3030 ●
Series
High Velocity Series 2
Industrial Air Curtain
Submittal Package
Submitted by:
Mars Air Systems, LLC
14716 S. Broadway
Gardena, CA 90248
MARS AIR SYSTEMS, LLC
GARDENA, CA
●
© Copyright Mars Air Systems, LLC 2014
Company Seal or Stamp
USA
●
www.marsair.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HV2 Series and is the answer not in the manual?

Questions and answers

Related Manuals for Mars HV2 Series

Summary of Contents for Mars HV2 Series

  • Page 1 Company Seal or Stamp (Electronic Signature Preferred) NOTE: Mars Air Systems, LLC reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased equipment.
  • Page 2 CSI Spec Reference Links NOTE: Mars Air Systems, LLC reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased equipment. MARS AIR SYSTEMS, LLC GARDENA, CA ●...
  • Page 3 1450 with a 17% reduction in performance. NOTE: Mars Air Systems, LLC reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased equipment.
  • Page 4 Air Curtain Only Furnace Only NOTE: Mars Air Systems, LLC reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased equipment. MARS AIR SYSTEMS, LLC GARDENA, CA ●...
  • Page 7 Single Pole, R.G.W. 99-182 - Cover, Lockable, Clear NOTE: MARS AIR SYSTEMS, LLC reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased equipment.
  • Page 8 3. All wiring must be per local and NEC (National Electric Code) codes. 1. Mars door limit and magnetic reed switches are 4. Panels or controllers may be required. Refer to wiring available with NEMA 1, 4X and 7 ratings. Contact the diagram inside the control panel box.
  • Page 9 Document No: ACC-IOM Date: 04/13/2013 Bracket Installation 1. Side Extension Plates: For doorways wider than the air curtain, use combination of Side Extension Plates and Adjustable Mounting Brackets. (FIG. 5) FIG. 7 (WMI/WMH Shown) FIG. 5 (LPV SHOWN) 2. Adjustable Mounting Brackets: For installation of air curtain over drum-style roll-up door, use Extended Wall Mounting Brackets.
  • Page 10 STERLING “XF” SERIES CONVERTIBLE VENTING TYPE TUBULAR PROPELLER UNIT HEATER XFS-1 DESCRIPTION The Sterling “XF” Series Convertible Venting Type Tubular Propeller Gas- Fired Unit Heater offers a highly efficient, extremely durable alternative to the traditional clam shell design. These propeller type units combine the latest tubular heat exchanger and in-shot burner technology with the quality and reliability you have come to know from Sterling.
  • Page 11 “XF” CONVERTIBLE VENTING TUBULAR PROPELLER PERFORMANCE AND DIMENSIONAL DATA Unit Capacity (MBH) PERFORMANCE DATA† Input - BTU/Hr. 100,000 125,000 150,000 175,000 200,000 250,000 300,000 350,000 400,000 (kW) (29.3) (36.6) (43.9) (51.2) (58.6) (73.2) (87.8) (102.5) (117.1) Output - BTU/Hr. 83,000 103,750 124,500 145,250...
  • Page 12 Warning: To reduce the risk of fire, electric shock, or injury to persons, do not use replacement parts that have not been recommended by the manufacturer. OVERVIEW GENERAL SAFETY INFORMATION Mars Curtains Use this product only in the designed to cover door manner intended by the openings, providing both manufacturer.

  • Page 13: Receiving And Inspection

    Verify that all parts, components and accessories, and the correct quantities of each have been received. If any items are missing, report shortages to Mars Air Systems directly to arrange for obtaining the missing items. Again, verify quantities received against those on the Bill of Lading only, as multiple shipments may be involved.
  • Page 14 4. power or motor leads and the motor will rotate the WARNING opposite direction. Make sure all motors are The following items must all be completed by a qualified turning in the same and proper direction. (FIG. 2) installer and checked off when completed 5.

  • Page 15: Maintenance

    DISCLAIMER exterior components of the housing. Mars reserves the right to change specifications and 3. To access the interior of the product, remove the air product design without notice. Such revisions do not intake grille and/or air intake filter.
  • Page 16 Document No: HT-IOM Date: 10/20/2023 HEATED PRODUCTS SUPPLEMENT NOTE Before proceeding, refer to the unit’s specific IOM Manual for safety, installation, and startup information. Verify proper voltage to the product per local and NEC codes. Ensure proper rotation for units with three phase motors.
  • Page 17 Hot Water and Steam Heated Products The transition section(s) are shipped knocked down and are to be field assembled and installed per their Hot water and steam heated products are certified only supplemental instructions (FIG. 6). Exceptions are the for indoor use. Low Profile 2, Standard 2, High Velocity Wind Stopping (WMI, WMH) and WindGuard (BD) series, 2, Extra Power 2, and Phantom series units are shipped which are shipped with fully assembled transitions.

  • Page 18: Troubleshooting

    TROUBLESHOOTING PROBLEM CAUSE SOLUTION NO AIR BLOWING - No power being supplied to the unit OUT OF DISCHARGE - Confirm power source / check if in on position from the electrical power source NOZZLE - Circuit breaker is tripped - Reset circuit breaker - Blown fuses on power supply - Replace fuses - Allow the motor to cool down;...

  • Page 19: Troubleshooting Motor

    TROUBLESHOOTING MOTOR To determine if the motor is in good operating condition, compare measured motor resistance at the motor terminals to the values shown below. MARS MOTOR RESISTANCE READINGS Single Phase Motors MOTOR WIRES OR TERMINAL (T) OHM READINGS HIGH SPEED (1750) MEDIUM SPEED (1650) LOW SPEED (1450)

  • Page 20: Warranty

    Mars’ warranty coverage, period, extent, and limitations apply to the product only. It does not apply Date Purchased: ____________________________ to labor. Mars warrants that the Mars product 1) is Dealer Purchased From: ______________________ free from defects in materials and workmanship, and 2) conforms to Mars’...
  • Page 21 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC SECTION 23 34 33 AIR CURTAINS Important Note: This specification contains hidden text appearing in red. To show or remove hidden text in MSWord, click the “File” tab or “Office” icon on the top-left corner, select “Options,” select “Display,”...
  • Page 22 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Section 23 22 13- Steam and Condensate Piping: Steam heating piping to units. Section 26 05 00 – Equipment Wiring: Connections to building power distribution. REFERENCES ASTM A240 / A240M -10 – Standard Specification for Chromium and Chromium.

  • Page 23: Quality Assurance

    Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Product data and certification letter indicating percentages by weight of post- consumer and pre-consumer recycled content for products having recycled content. Selection Samples: For each finish product specified, two complete sets of color chips representing manufacturer's full range of available colors and patterns.
  • Page 24 PART 2 PRODUCTS MANUFACTURER Acceptable Manufacturer: Mars Air Systems, LLC; 14716 South Broadway St., Gardena, CA 90248. Tel: (310) 532-1555 or (800) 421-1266. Fax: (310) 324-3030. Email: info@marsair.com. Web: www.marsair.com. Delete one of the following two paragraphs: coordinate with requirements of Division 1 section on product options and substitutions.
  • Page 25 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Size: Unheated: 15-5/8 inches deep by 14 inches high (including discharge nozzle) by width of unit. Electric Heated: 21-3/8 inches deep by 14 inches high (including discharge nozzle) by width of unit.
  • Page 26 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC HV296-2: 96 Inch (2440 mm) Wide Units: 2447 feet/min (12.4 m/s) two 1HP motor/fan assemblies. HV2108-3: 108 Inch (2743 mm) Wide Units: 2745 feet/min (13.9 m/s) two 1HP motor/fan assemblies.
  • Page 27 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC NH2120-3: 120 Inch (3050 mm) Wide Units: 2678 feet/min (13.6 m/s) single 1HP motor/fan assembly. NH2144-3: 14 Inch (3660 mm) Wide Units: 2447 feet/min (12.4 m/s) single 1HP motor/fan assembly, Air Speed at Floor: Service entry doors require a minimum of 1600 fpm (8.13 m/s) at 3 feet...
  • Page 28 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Gas Heaters: Provide field mounted indirect natural gas fired, power vented duct furnace, with aluminized steel heat exchanger and die-formed stainless steel insert burners; manifolds, orifices, flame sensor, and igniter easily removable as an assembly.
  • Page 29 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Optional Integrated BMS controls Optional BACnet MS/TP Optional BACnet IP Optional adaptive fan speed control based on existing field conditions. Field mounted outdoor temperature sensors required. Motor Control Panels for Electric Heated Units: Motor Control Panel is included for all electric heated units.
  • Page 30 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Mounting: Factory mounted on left hand side of air curtain housing. Provide with remote mount thermostat for field installation. Electrical components UL/CUL listed. Panels UL 508A listed. Optional Digital Programmable Controller:...

  • Page 31: Installation

    Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Door-Activated Limit switch(s): Provide, field installed 250-Volts, 20 amps limit switch to control air curtain(s) as follows; Automatic on/off control, activates air curtain when door is opened and turns off when door is closed. Provide limit switch for direct control one 1 HP or up to two 1/2 HP single phase motors without a separate control panel.
  • Page 32 Mars High Velocity Series 2-CSI-Spec Revised 5/3/2023 MARS AIR SYSTEMS, LLC Anchor air curtains securely in place to supports. Coordinate with sheet metal flashing as specified in Section 07 62 00. Install joint sealants as specified in Section 07 92 00.
  • Page 33 HV2 Series CSI spec (Word doc) NOTE: Mars Air Systems, LLC reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased equipment.

This manual is also suitable for:

Hv296-2i ts seriesHv2108-3i ts seriesHv2120-3i ts seriesHv2144-3i ts series

Table of Contents