Installation Manual
H3C S3610 Series Ethernet Switches
3.4.2 Removal of Optional Interface Modules
Step 1: Wear ESD wrist strap and disconnect the power of the switch.
Step 2: Use a screwdriver to unscrew the captive screws at the both sides of the
interface module.
Step 3: Pull the card towards the operator until the interface card is completely apart
from the switch bottom.
Caution:
When removing/installing the optional interface modules, pay attention to the following:
When removing /installing the module, do not apply too much force during the
operation or touch the components on the surface of the module.
If the Module is removed and there is no need to mount a new one, mount the blank
filler panel in time to keep the dust out and ensure the normal ventilation of the
switch.
3.5 Verifying Installation
The correct power source is used.
The ground wire is securely connected.
Both of the console cable and power cord are correctly connected.
All the interface cables are routed indoors. If there are cables outdoors, check that
the socket strip with lightning protection and lightning arresters for network ports
have been correctly connected.
3-15
Chapter 3 Installing the Switch