Table of Contents
Advertisement
Installation Manual
H3C S3610 Series Ethernet Switches
(1)
(1) Screw hole used to fix the mounting ear to the cabinet (Use one M6 screw)
(2) Screw hole used to fix the switch to the mounting ear
Figure 3-1 Appearance of a standard front mounting ear
II. Introduction to guide rail
Figure 3-2 shows the appearance of a guide rail.
Slotted hole 1: Used to fix the guide rail to the rear bracket. You can adjust the screw hole
position according to the position of the switch.
Cooling hole: Used for heat dissipation between switch and cabinet
Slotted hole 2: Used to fix the guide rail to the front bracket
Figure 3-2 Appearance of a guide rail
III. Use front mounting ears to install a switch
Note:
When installing the S3610-52M/S3610-52M-DC switch, you cannot use the front
mounting ears only, but use the front mounting ears in conjunction with a tray or guide
rails.
Follow these steps to mount a switch into a 19-inch standard cabinet:
(2)
3-2
Chapter 3 Installing the Switch
Advertisement
Table of Contents
