FUTABA PCM1024H Instruction Manual page 27

and Method
1) are displayed when the cursor is in
the "mas" position.
when the cursor is in the "slv" position.
2) To activate XON or YON mixing, press the
or key, The character
appear next to the appropriate channel on the
left side of the screen to indicate that
has been set.
•Combinations allow more efficient use of
the number of mixing circuits. An example
is shown below.
When are not used, three circuits and
are required for the mixing program shown
below. Programmable mixing is performed from
Aileron to Elevator and Rudder, and from Eleva-
tor to Rudder. This is the same as AIL -> ELV ->
RUD mixing.
are displayed
Displayed when cursor is in "mas"
position.
Indicates that Master channel is
"slaved" to another circuit.
will
or
The same mixing program as in Example 1 can be
set up using only two 2 mixing circuits when the
and functions are used.
MX1 is set to AIL -> ELV mixing.
MX2 is set to ELV -> RUD mixing.
The cursor is moved to the MX1 "slv" position,
and is set. The cursor is then moved to the
"mas" position and
OFF (Set to
).
This is also the equivalent of AIL -> ELV -> RUD
mixing.
Setting MX1 as the MX2 Master channel in the
example is the same as setting
• Combinations are effective when the number
of mixing circuits is insufficient, and when
PROG-MIX circuits are mixed with built-in
mixing circuits.
is set. MX3 is turned