Idle-Up - FUTABA PCM1024H Instruction Manual

Four separate Programmable Mixing circuits allow almost infinite mixing combinations. The
features of this program provide the modeler with unlimited versatility in trimming and
controlling complex, high-performance models.
• Mixing of any two channels is possible.
• Four completely independent mixing circuits
are available.
• Mixing amounts can be adjusted independently
in either direction from neutral or offset point.
•The PROG-MIX ON/OFF
selected.
•The point at which the mixing direction re-
verses is fully-adjustable.
•PROG-MIX circuits can be mixed with or
"slaved" to built-in mixing functions.
Slave Channel
Master Channel
When the SET program
key is pressed, the
CHANNEL SETTING
screen is displayed.
Mixing Circuit Number
PROGRAMABLE MIX
Programmable Mixing
Switch can be
Operation (Mixing) Amount
+ and - indicate the
direction of mixing
Circuit is usable when set
to ON
Switch Mode (ON/OFF
Switch Selection)
• P R O G - M I X circuits can be mixed with each
other.
•Trim corrections on the "Master" channel can
be added to the slave channel or not, as de-
sired.
• Bi-directional mixing can be accomplished
using two mixing circuits (Ex: Flapperons)
•Adverse coupling of control inputs in fixed-
wing aircraft can be eliminated. (Ex: Tendency
to roll when rudder is applied in knife-edge
flight.)
When ON, the trim inputs to the
"Master" channel are also mixed
to the "Slave" channel. When
OFF,trim on the "Master"
channel affects the "Master"
channel only.
1. Always ON
2. ELEV.D/R Switch
3. RUD.D/R CH9 Switch
4. IDLE UP 1 and 2 (Both
switches must be ON)
5. GEAR (CH5)
Indicates the control stick
position that the mixing
— reference point (R/L or
U/D Direction Change
Point) is offset to.