Table of Contents
Advertisement
Trainer
Trainer system starting and setting
FX-40 trainer system makes it possible to chose
which channels and operation modes are to be used
at the instructor's transmitter. Because the switch
and rate of each channel can be set, the training
method can also be matched to the student's skill
level. Two transmitters must be connected by
an optional Trainer Cord, and the Instructors'
transmitter should be programmed for trainer
operation, as described below.
When the Instructor activates the trainer switch,
the student has control of the aircraft (if MIX or
FUNC mode is turned on, the Instructor can make
corrections while the student has control). When
the switch is released the Instructor regains control.
This is very useful if the student gets the aircraft
into an undesirable situation.
(The display screen is an example. The screen depends on the model type.)
NOTE: This trainer system can be used in the
following manner;
1. In the FX-40 transmitter and a conventional
transmitter, if the channel order is different. It
is necessary to match the channel order in
the Function Menu when connecting it with
other than a FX-40.
2. When the T14MZ is used as the Teacher,
set the modulation mode of the student'
s transmitter to PPM. If being used as the
student, set the FX-40 to the modulation
When the Instructors' transmitter is a T14MZ,
FX-40, 12Z, T9Z, T9C or T7C transmitter, it
should be switched to PPM mode.
3. Be sure that all channels work correctly in
Corresponding types of transmitters:
Non-corresponding types of transmitters:
<System Menu>
31
Advertisement
Table of Contents
