Table of Contents
Advertisement
Updating
update the program.
Updating procedure
Note: If the battery fully discharges during
program updating, updating will fail. When
less, always recharge the battery before
updating.
Note: The model data in the transmitter will not
be changed after updating, but to be safe,
back up the model data before updating.
Update switch
Normal operation mode
Card slot
into the card slot.
(update switch) at the side of the card slot in
the up direction.
seconds later, the screen shown below will
appear. To abort updating, turn off the
transmitter power.
appear. Turn off the power to the transmitter
4. When the rotary switch is pushed, updating
Update mode
starts. During updating, the bar graph moves
to the right.
shown below appears.
LED goes off, switch the update switch in the
down direction.
completed, turn on the power and then
check the system program version at the
system menu information screen.
<Data>
129
Advertisement
Table of Contents
