Table of Contents
Advertisement
Curve setting operation
This section describes the setting procedure of curves which are used with the AFR function and each
mixing function.
Curve type selection
When the curve type select button on the mixing function screen or other screen is touched, the setup
screen shown below is called.
Setting by curve type
When the curve type is selected as described above, adjustment buttons corresponding to the curve type
appear on the original screen. Adjust each curve as described below.
Linear curve adjustment
Rate A and Rate B can be adjusted separately or
simultaneously.
*[Separate] mode:
separately.
*[Combined] mode:
simultaneously.
1. Select the setting mode.
*Initial value: +100.0%
The curve can also be offset horizontally in the
vertical direction and the rate reference point can
be offset to the left or right.
*Initial value: +0.0%
124
<Data>
1. Touch the button of the curve type you want to use.
*The curve type changes and the display returns to the original screen.
of original function
Curve type selection
move the reference point to the
left or right.
*Initial value: +0.0%
(Linear curve)
Advertisement
Table of Contents
