Reversing The Throttle Stick - FUTABA 6XA Instruction Manual

decreases for counterclockwise motion. When you are satisfied with the spring tensions, you
may close the transmitter. Very carefully reinstall the rear cover. When the cover is properly
in place, tighten the four screws.
Changing the T6XAs/Hs transmitter's mode
If you wish to change the mode of the transmitter, say
from mode 1 to mode 2, turn on the transmitter holding the two
buttons down. You'll see a display "STCK X," where X
MODE
is a number representing the current transmitter mode. Press the
plus (+) or minus (–)
effect of you changes when you next turn on your transmitter. In some cases, you'll have to
swap the throttle detent mechanism with the elevator centering mechanism. This can be done
by Futaba.
Reversing the throttle stick's action
If for some reason you wish to reverse the action of the throttle
stick (for example, to get throttle trim at the top of the stick's travel), you
may reverse it by turning on the transmitter holding the two
buttons down, then pressing either of the
TREV menu. You may then use the (+) or (–) keys to switch between normal and reversed
functioning.
key to change the mode number as desired. You'll see the
DATA INPUT
MODE
MODE
buttons to get to the
– 6 –
flashing