Para; Rest; Drsw - FUTABA 6XA Instruction Manual

PARA — Parameter Menus
The parameter function includes a number of submenus that are used to input basic
model data settings. This is best understood by viewing the menu structure on p. 14. These are
placed in a submenu under
There are five submenus within the
(Dual Rate Switches),
menus, you press the
CURSOR
is described in more detail below.
REST — Data Reset (PARA sub-function)
The Reset function is used to clear out an existing set of model data. This may be used to
get a "fresh start" so that you may be begin with a clear memory before you input new model
settings into a memory that had been used for another model. It resets all data to initial values.
A safety feature allows you to verify that you wish to reset before all data are lost.
Resetting the memory
1. Press on the
MODE
button until
CURSOR
2. To reset the memory, press both
word appears blinking on and off in the display.
SET?
3. If you are sure you wish to reset, press both
simultaneously again. This resets the memory. If you do not wish to reset the data, press the
key or a
CURSOR
CAUTION: WHEN YOU COMMAND RESET, YOU'LL ERASE THE MEMORY
YOU'RE IN AND LOSE ANY PROGRAMMING YOU HAVE ENTERED. DON'T DO
THIS UNLESS YOU ARE POSITIVE YOU WANT TO FLUSH OUT THAT MEMORY
AND START FROM SCRATCH.
because they are not changed very often.

PARA

PARA

(Model Type), and
ACRO/HELI
key to step through them in sequence. Each of these commands
Use the CURSOR key to move to
the other submenus within the
PARA function
buttons until the
PARA
appears.

REST

DATA INPUT
key or return to the regular window.
MODE
menu, including
REST
(Modulation). To access these
MOD
PARA includes five
functions:
•Data reset [RSET]
•Dual Rate Switch
•ACRO/HELI model type
•Modulation
window appears, then press the
keys simultaneously. The
DATA INPUT
– 40 –
(Data Reset),

DRSW

keys