Model Select "M-Sel - FUTABA 3PKS Instruction Manual

Model Selection "M-SEL"
Use this function to call a new model # or an existing model # to set new model data.
The T3PKS transmitter can store the model data for 20 R/C cars. The CAMPac-16K
(option) can store the model data for 10 more models.
The model numbers are "M1" to "M20" at the transmitter and "E21" to "E30" at the
CAMPac-16K. When the CAMPac-16K is not installed, "E21" to "E30" are not dis-
played.
Calling model memories of different modes (HRS, PCM, or PPM mode)
After a model memory was called, signals are output in the mode before the model
memory was called until the transmitter power is turned off. Use the transmitter after
turning the power off and then back on.
CAMPac-16K (option)
When using the CAMPac-16K, operation must be initialized so that the CAMPac-16K
can be used with this transmitter. When "INITIALIZE?" appears on the screen at pow-
ering ON, press the (+) button. This automatically initializes operation. This action is
unnecessary thereafter.
Inserting and removing the DataPac
Insert and remove the CAMPac-16K with the transmitter power turned off. If the power
is turned off and the DataPac is removed when a CAMPac-16K model number (E21 to
E30) was selected and the power is turned back on while the CAMPac-16K is removed
and any button is pressed after "SELECT ERROR" is displayed, model number M1 is
forcefully selected.
Calling the setup screen
*Calling from menu screen
(Opening Screen)
MENU 1
MENU 2
Press t
* When the direct call button is set,
the setup screen is also called by the
following method:
(Opening Screen)
DIRECT SEL
Press the button set
at this function.
90
Menu screen call
by button
MENU1/2 selection
by button
Select the function
by button
he button
Press t
he button
Select the model # by (JOG) button
Model Selection "M-SEL"
Current model # and model name