Model Select - FUTABA 32MZ Instruction Manual

Model Select

This function is used to load the settings of the desired
model into the T32MZ's memory.
The settings may be selected from either the transmitter's
built-in memory or a microSD card. The name of the
model stored in the transmitter and the microSD card
may be changed. This can be very useful to tell different
models settings apart. Each model name can be as long
as 32 characters, and the model name always appears in
the display screen.
● Touch the [Model Select] button in the Linkage Menu to call the setup screen shown below.
●Check mark
(Model list)
Model call
1. Touch the "Location" icon, and select the location
to which the desired model is to be saved.
Transmitter icon: Transmitter memory
microSD card icon: microSD card
2. Touch the desired model in the model list.
3. Touch the [Select] button.
4. Touch [Yes] to call the model. (When you want to
cancel model call, press [No].)
Model addition
1. Touch the [New] button.
2. Touch [Yes] to add the model. (When you want to
cancel model addition, touch [No].)
*When a new model is added, the Model Type
screen is automatically displayed. Check or
change the model. If there are no changes,
touch the Model Type icons.
*The added model is displayed in the model list.
*When Model addition, a link with a receiver is
required. When not relinking, a new model can't
use telemetry.
Model deletion
1. Touch the "Location" icon or the model you want
to delete in the model list. (The model currently
selected cannot be deleted.)
2. Touch the [Delete] button.
3. Touch [Yes]. (When you want to stop model
deletion, touch [No].)
The Model Selection function performs model
addition, selection, deletion, copy, and model
name setting.
●Return to Linkage Menu
(The display screen is an example. The screen depends on the model type.)
The Copy function is used to copy one set of model data
into a second memory within the transmitter and the
microSD card. It may be used for getting a head-start on
setting up models with almost the same settings (only
differences need to be modiied, instead of entering the
complete model from scratch). Also, this function may be
used to make a backup copy of a model setup before any
changes are made.
●"Location"
Model name change
1. Select the model by touching the "Location" icon
or the desired model in the model list.
2. When [Rename] is touched, a keyboard appears
on the screen.
3. Enter the model name from this keyboard.
*Up to 32 characters can be input at the model
name.
Model copy
1. Select a model to copy from the list.
2. Check mark is attached to the model and a
"Copy" button is displayed on the right.
3 . T o u c h t h e " C o p y " b u t t o n a n d t o u c h t h e
"Destination" button and select the copy storage
destination. (Transmitter or microSD card)
4. Touch the center [Copy] button.
5. When [Yes] is touched, copying is executed. (When
you want to cancel copying, touch [No].)
*If there is no model with the same name in the
copy destination, the name of the copied model
is saved. If there is a model of the same name, a
number is added at the end of the model name
and the model is copied. You can change the
name later.
*When the model data is copied, the model date
is reset to the date that the copy was done.
＜ Linkage Menu ＞
● I t c a n s o r t
in order of
the date or
a name.
77