Nomenclature / Handling - FUTABA 2PL Instruction Manual

Nomenclature / Handling

Transmitter T2PL
Throttle Trim Lever (DT2)
Adjusts the throttle in small increments so the
model will not move at neutral.
Power Switch
When slid upward,
the power is turned on.
LCD screen
Power switch turned on: Beep confirmation
sound is generated and the model name is
displayed for about two seconds and then
the initial screen appears.
(Initial screen)
•Model memory number display
•Battery voltage display
Grip Handle
E.S.C. MC230CR
/ MC330CR
Checker LED
Pushbutton
switch
MC230CR
Power switch
(*1)
(*1)
Digital trim DT1, DT2, and D/R operation
Push the lever to the left or right (up or down).
The current position is displayed on the LCD screen for about two seconds.
Each step is indicated by a tone. When the trim exceeds the maximum trim
adjustment range, the beep tone will change and the servo will not move
any further. Remember, the trims are digital so the position of each trim is
remembered for each model separately.
Applicable motors
•Use the MC230CR with a motor with 20T or more turns.
•Use the MC330CR with a motor with 13T or more turns.
*If a motor with a number of turns smaller than the above is used, the heat
protector and overcurrent protection circuit may operate. The number of turns
of the motor is a criteria only. Depending on the running conditions, the
protection circuit may operate even if the condition above is satisfied.
(Orange)
(Blue)
(Black)
(Red)
Antenna
Steering Trim Lever (DT1)
Adjusts the steering in small increments so
the model will run straight.
Select Button (SELECT)
Press the Select button to select the
desired function screen.
Steering Wheel
Turn model to left or right.
Throttle Trigger
Control the speed of the model and movement
forward and backward.
Steering Dual Rate Lever (D/R)
Adjust the vihicle's steering sensitivity across
the entire range.
(Number of turns is criteria.)
Motor connector
Connects to the motor.
(Orange) is positive. (Blue) is negative.
If the motor rotates in the wrong
direction, interchange the connections of
this connector.
Nicd battery connector
Connects to the running Nicd battery.
(Red) is positive. (Black) is negative.
Nicd battery 6~7 cells (7.2~8.4V)
Receiver connector
Connects to the receiver throttle channel.
Miniature screwdriver
Accessory. Use to press the
pushbutton switch.
(*1)
(*1)
7