Nomenclature / Handling - FUTABA 2PH Instruction Manual

Transmitter T2PH / T2PHKA
Battery Level
Indicator
*Two LED display to indicate
battery voltage level.
*If the Red led flashes, replace
batteries.
Power Switch
*When slid upward,
the power is turned on.
Trim Panel Cover
*Open the cover by sliding it
to the left.
¥ Servo Reversing Switch (P13)
¥ Steering EPA (only 2PHKA) (P14)
¥ Throttle EPA (only 2PHKA) (P14)
¥ Steering D/R (only 2PHKA) (P14)
E.S.C. MC230CR
/ MC330CR
Checker LED
Pushbutton
switch
MC230CR
Power switch

Nomenclature / Handling

Antenna
Grip Handle
Applicable motors
•Use the MC230CR with a motor with 20T or more turns.
•Use the MC330CR with a motor with 13T or more turns.
*If a motor with a number of turns smaller than the above is used, the heat
protector and overcurrent protection circuit may operate. The number of turns
of the motor is a criteria only. Depending on the running conditions, the
protection circuit may operate even if the condition above is satisfied.
(Orange)
(Blue)
(Black)
(Red)
(T2PH)
Steering Wheel
*Turn model to left or right.
Steering Trim (P13)
*Adjusts the steering in small increments
so the model will run straight.
Throttle Trim (P13)
*Adjusts the throttle in small increments
so the model will not move at neutral.
Throttle Trigger
*Control the speed of the model and movement
forward and backward.
(T2PHKA)
(Number of turns is criteria.)
Motor connector
Connects to the motor.
(Orange) is plus. (Blue) is minus.
If the motor rotates in the wrong
direction, interchange the connections of
this connector.
Nicd battery connector
Connects to the running Nicd battery.
(Red) is plus. (Black) is minus.
Nicd battery 6~7 cells (7.2~8.4V)
Receiver connector
Connects to the receiver throttle channel.
Miniature screwdriver
Accessory. Use to press the
pushbutton switch.
7