4-Step Buttonhole (Model 2600); Adjusting The Buttonhole Stitch Density - ELNA 2600 Instruction Manual

q
w
t
r
z
q
e
w
r
x c
t
n
e
v b
y

4-Step Buttonhole (Model 2600)

Machine setting
q Stitch:
w Stitch width:
4 – 5
e Stitch length:
0.5 – 1
r Thread tension: 1 – 5
t Presser foot:
J
z Set the stitch selector dial on "
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
Draw both needle and bobbin threads to the left.
Move the slider toward you so that the top mark w
on the slider meets the start mark q.
q Start mark
w Top mark
e Needle thread
r Bobbin thread
NOTE:
The scale on the slider is engraved in centimeters.
x Sew forward until you reach the front marking of your
buttonhole. Stop sewing with needle on left side.
c Raise the needle to its highest position.
Set the stitch selector dial at "
Stop sewing with needle on right side.
v Raise the needle to its highest position.
Set the stitch selector dial at "
needle reaches the back marking of the buttonhole.
Stop sewing with needle on right side.
b Raise the needle to its highest position.
Set the stitch selector dial at "
then stop sewing. Set the stitch length dial to "0" and
the stitch selector dial at straight sewing.
Sew a few locking stitches.
n Raise the needle and presser foot. Remove the fabric
from the machine and cut the sewing thread. Insert a
pin inside the bartack.
Cut buttonhole open with a seam ripper.
Be careful to not cut the stitches.
t Pin
y Seam ripper

Adjusting the buttonhole stitch density:

Set the stitch length dial between "
buttonhole stitch density.
27
".
". Sew 5 stitches.
". Sew until the
". Sew 5 stitches,
" to adjust the