Button Sewing - ELNA 2600 Instruction Manual

Hide thumbs Also See for 2600:
Table of Contents

Advertisement

q
2
r
y
w
e
w
e
t
q

Button Sewing

Machine setting
q Stitch:
2
w Stitch width:
Adjust as necessary
e Stitch length:
Any
r Thread tension: 3 – 7
t Presser foot:
F
y Feed dog:
Lowered
Adjust the stitch width to match it with the span of the
holes in the button. Turn the flywheel to check if the
needle enters into each hole in the button.
Lower the foot to hold the button in place.
The holes in the button should align with the slot of the
foot.
A pin can be placed on the foot to form a shank.
Make sure to check if the needle enters into both holes
in the button.
q Pin
Sew about 10 stitches.
Raise the presser foot and remove the fabric. Cut the
needle and bobbin threads leaving 8" (20 cm) tails.
Bring the needle thread between the button and fabric
through the holes in the button.
Pull the needle thread to pick bobbin thread up to the
right side of the fabric.
Wind the threads to from a shank and tie them together.
w Needle thread
e Bobbin thread
NOTE:
Raise the feed dog after sewing.
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2600 series 2800 series

Table of Contents