Wacom DTZ-2100D User Manual page 5

So that the Cintiq21UX may be Used Safely
Do not place the product
■
on unstable surfaces.
Do not place the product where it is
likely to totter, lean or be exposed
to strong vibrations. Doing so may
lead to the product falling, resulting
in injury and/or product failure.
Do not place heavy objects
■
on the product.
Do not put excessive weight, or place
heavy objects on the product. These
actions may cause product failure.
Do not place the product in
■
either very hot or very cold places.
Do not place the product in very hot
(35 degrees centigrade or more) or
very cold (5 degrees centigrade or
less) locations. Also, avoid placing
it in locations with severe temperature
fluctuations as this may adversely affect
the product and cause product failure.
■ Do not disassemble the product.
Do not disassemble or modify
the product, as these actions
m a y l e a d to fi r e , exces sive
generation of heat, electrical
shock or injury. The guarantee
on the product will become null
and void if the product is ever
disassembled.
4
Caution
Be sure to fix the product to the stand
■
with screws prior to lifting.
If the stand is not attached prior to
lifting, it may fall resulting in injury and/or
damage to Cintiq, the floor or furniture.
It may also unexpectedly rotate, causing
it to be dropped. If the product must be
lifted without being fixed to the stand, be
sure to remove the body from the stand
prior to lifting.
Do not operate the incline adjustment
■
levers when the product has been removed
from the stand and there is no
weight on the stand, or when the
stand is otherwise empty.
The stand is spring-loaded and may
close suddenly, resulting in injury or
damage to the stand.
Be careful not to get your fingers
■
caught in the closing mechanism
when closing the stand.
Do not place the product face-up
■
when the cable is sticking out from
the shaft bearing.
Doing so puts excessive stress on the
base of the cable and may cause product
failure. Place the main body that has
been removed back in the stand or, if
you want to use the product face-up,
adjust the cable so that it protrudes from
the upper part of the body instead of the
shaft bearing.