Wacom DTZ-2100D User Manual page 21

Remove the screws holding
3
the large cover in place.
4
Pull off the shaft bearing.
Remove the stopper and
5
set it aside so that it doesn't become
lost.
Remove the large cover.
6
Put the cable through the gap on
7
the backside of the display so that it
sticks out of the top.
Cover the area where the shaft
8
bearing previously was with the small
metal cover (see page 9), securing it
in place with the four screws made to
go with the small cover (see page 9).
Place the large cover back in its origi
9
nal position, securing it in place with
the screws removed in step 3.
Turn the tablet over so that it is face
1 0
up.
20
5
stopper
7
4
6
8
9