The Pl-720 Display; The Auto-Adjust Function; The Pl-720 Power Saving Function - Wacom DTF-720 - OTHER User Manual

The PL-720 Display

The Auto-Adjust Function

In order to ensure optimal display image quality, this product utilizes the Auto-Adjust
function. When the Auto-Adjust function is operating, it may take a short time before the
screen displays properly. The settings initiated by Auto-Adjust are saved in the display.
If the Auto-Adjust function is operating, the horizontal and vertical positions as well as the phase
and pitch of the display are adjusted automatically when the display mode is received. The Auto-
Adjust function becomes operational when the horizontal frequency is in the 30-80KHz and the
vertical frequency is in the 50-75Hz range.
When the Auto-Adjust function is operating, only the power switch is operational.
Pen calibration may be necessary after adjusting screen position. (

The PL-720 Power Saving Function

This product is in compliance with VESA and ENERGY STAR power-saving guidelines.
When connected to a Display Power Management (DPMS)-compatible computer and
graphics board, the power savings indicated below are automatically realized during
times of non-operation.
Computer Horizontal
Activity Synchronizing
Signal
Turned On Yes
Stand-by Mode No
Suspend Mode Yes
Off Mode No
* Depending on the specifi cations and settings of your computer and video card, when in
standby and suspend modes, the power lamp may only light up orange.
1 _ P L 7 2 _ U Z - 3 3 2 ( C ) _ E n . i n d d 1 2
Vertical Picture
Synchronizing Signal
Signal
Yes Yes
Yes No
No No
No No
P13)
Power Power Lamp
Consumption
37W or less Blue
Less than 2W Orange/Blue*
Less than 2W Orange/Blue*
Less than 1W Orange
7 . 1 1 . 2 7 6 : 5 6 : 1 3 P M