Guidelines For Using 1200 Series Lightweight Access Points; Hardware Features - Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP Hardware Installation Manual

Chapter 1 Overview

Guidelines for Using 1200 Series Lightweight Access Points

You should keep these guidelines in mind when you use a 1200 series lightweight access point:
•
•
•
•
•

Hardware Features

This section describes access point features. Refer to
list of access point specifications.
Key hardware features of the 1200 series access point include:
•
•
•
•
•
•
•
OL-8370-04
The access points can only communicate with Cisco 2006 series wireless LAN controllers or 4400
series controllers. Cisco 4100 series, Airespace 4012 series, and Airespace 4024 series controllers
are not supported because they lack the memory required to support access points running Cisco IOS
software.
The access points do not support Wireless Domain Services (WDS) and cannot communicate with
WDS devices. However, the controller provides functionality equivalent to WDS when the access
point associates to it.
The access points support eight BSSIDs per radio and a total of eight wireless LANs per access
point. When a lightweight access point associates to a controller, only wireless LANs with IDs 1
through 8 are pushed to the access point.
The access points do not support Layer 2 LWAPP. They must get an IP address and discover the
controller using DHCP, DNS, or IP subnet broadcast.
The access point console port is enabled for monitoring and debug purposes (all configuration
commands are disabled when connected to a controller).
Dual-Radio Operation, page 1-4
LEDs, page 1-5
Ethernet Port, page 1-5
Console Port, page 1-6
Power Sources, page 1-6
UL 2043 Certification, page 1-6
Anti-Theft Features, page 1-6
Guidelines for Using 1200 Series Lightweight Access Points
Appendix C, "Access Point Specifications,"
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
for a
1-3