Configuring Rip - Cisco 1812W - Integrated Services Router Wireless Configuration Manual

Configuring Dynamic Routes

Configuring RIP

Perform these steps to configure the RIP routing protocol on the router, beginning in global
configuration mode:
Command
Step 1 router rip
Example:
Router> configure terminal
Router(config)# router rip
Router(config-router)#
Step 2 version {1 | 2}
Example:
Router(config-router)# version 2
Router(config-router)#
Step 3 network ip-address
Example:
Router(config-router)# network 192.168.1.1
Router(config-router)# network 10.10.7.1
Router(config-router)#
Step 4 no auto-summary
Example:
Router(config-router)# no auto-summary
Router(config-router)#
Step 5 end
Example:
Router(config-router)# end
Router#
For complete information on the dynamic routing commands, see the Cisco IOS Release 12.3
documentation set. For more general information on RIP, see
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
1-14
Chapter 1
Task
Enters router configuration mode, and enables RIP
on the router.
Specifies use of RIP version 1 or 2.
Specifies a list of networks on which RIP is to be
applied, using the address of the network of
directly connected networks.
Disables automatic summarization of subnet routes
into network-level routes. This allows subprefix
routing information to pass across classful network
boundaries.
Exits router configuration mode, and enters
privileged EXEC mode.
Appendix B, "Concepts."
Basic Router Configuration
OL-6426-02