Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 50

Configure Network Address Translation
Command
Step 5
no shutdown
Example:
Router(config-if)# no shutdown
Router(config-if)#
Step 6
exit
Example:
Router(config-if)# exit
Router(config)#
Step 7 interface type number
Example:
Router(config)#interface fastethernet 0
Router(config-if)#
Step 8 ip nat {inside | outside}
Example:
Router(config-if)# ip nat outside
Router(config-if)#
Step 9
no shutdown
Example:
Router(config-if)# no shutdown
Router(config-if)#
Step 10
exit
Example:
Router(config-if)# exit
Router(config)#
Step 11 access-list access-list-number {deny | permit}
source [source-wildcard]
Example:
Router(config)# access-list 1 permit
192.168.1.0 0.0.0.255
If you want to use NAT with a virtual-template interface, you must configure a loopback interface. See
Note
Chapter 1, "Basic Router Configuration,"
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
3-8
Chapter 3
Purpose
Enables the configuration changes just made to the
Ethernet interface.
Exits configuration mode for the Fast Ethernet
interface.
Enters configuration mode for the Fast Ethernet
WAN interface (FE0 or FE1) to be the outside
interface for NAT.
Identifies the specified WAN interface as the NAT
outside interface.
For details about this command and additional
parameters that can be set, as well as information
about enabling static translation, see the
Cisco IOS IP Command Reference, Volume 1 of 4:
Addressing and
Enables the configuration changes just made to the
Ethernet interface.
Exits configuration mode for the Fast Ethernet
interface.
Defines a standard access list indicating which
addresses need translation.
All other addresses are implicitly denied.
Note
for information on configuring a loopback interface.
Configuring PPP over Ethernet with NAT
Services.
OL-6426-02