Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 106

Configure the Root Radio Station
Configuration Tasks
Perform the following tasks to configure this network scenario:
•
•
•
An example showing the results of these configuration tasks is shown in the section
Example."
The procedures in this chapter assume that you have already configured basic router features as well as
Note
PPPoE or PPPoA with NAT. If you have not performed these configurations tasks, see
Router Configuration," Chapter 3, "Configuring PPP over Ethernet with NAT,"
"Configuring PPP over ATM with NAT,"
DHCP, VLANs, and secure tunnels.
Configure the Root Radio Station
Perform these steps to create and configure the root radio station for your wireless LAN, beginning in
global configuration mode:
Command
Step 1
interface name number
Example:
Router(config)# interface dot11radio 0
Router(config-if)#
Step 2 broadcast-key [[vlan vlan-id] change secs]
[membership-termination] [capability-change]
Example:
Router(config-if)# broadcast-key vlan 1
change 45
Router(config-if)#
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
9-2
Configure the Root Radio Station
Configure Bridging on VLANs
Configure Radio Station Subinterfaces
Chapter 9
as appropriate for your router. You may have also configured
Purpose
Enters interface configuration mode for the
specified wireless interface.
Specifies the time interval (in seconds) between
rotations of the broadcast encryption key used
for clients.
Note Client devices using static Wired
Equivalent Privacy (WEP) cannot use
the access point when you enable
broadcast key rotation—only wireless
client devices using 802.1x
authentication (such as Light Extensible
Authentication Protocol [LEAP],
Extensible Authentication
Protocol-Transport Layer Security
[EAP-TLS], or Protected Extensible
Authentication Protocol [PEAP]) can
use the access point.
This command is not supported on
Note
bridges.
See the Cisco IOS Commands for Access Points
and Bridges document for more details.
Configuring a Wireless LAN Connection
"Configuration
Chapter 1, "Basic
and Chapter 4,
OL-6426-02