Viewing The Default Configuration - Cisco 1812W - Integrated Services Router Wireless Configuration Manual

Viewing the Default Configuration

Table 1
Router
Cisco 1802
Cisco 1803
Cisco 1811
Cisco 1812
Viewing the Default Configuration
When you first boot up your Cisco router, some basic configuration has already been performed. All of
the LAN and WAN interfaces have been created, console and VTY ports are configured, and the inside
interface for Network Address Translation has been assigned. Use the show running-config command
to view the initial configuration, as shown in
If you are unable to view the initial configuration and you get a No Password Set error message, you
Note
must reset the initial password. For details, see the
"Troubleshooting".
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
1-2
Supported Interfaces and Associated Port Labels by Cisco Router (continued)
Interface
Fast Ethernet LANs
Fast Ethernet WANs
ATM WAN
Wireless LAN
BRI
Fast Ethernet LANs
Fast Ethernet WANs
ATM WAN
Wireless LAN
BRI
Fast Ethernet LANs
Fast Ethernet WANs
Wireless LAN
USB
V.92
Fast Ethernet LANs
Fast Ethernet WANs
Wireless LAN
BRI
USB
Chapter 1
Port Label
SWITCH and FE8–FE5 (top), FE x and
FE4–FE1 (bottom)
FE0
ADSLoISDN
LEFT, RIGHT/PRIMARY
ISDN S/T
SWITCH and FE8–FE5 (top), FE x and
FE4–FE1 (bottom)
FE0
G.SHDSL
LEFT, RIGHT/PRIMARY
ISDN S/T
SWITCH and FE9–FE6 (top), FE x and
FE5–FE2 (bottom)
FE0–FE1
LEFT, RIGHT/PRIMARY
1–0
MODEM
SWITCH and FE9–FE6 (top), FE x and
FE5–FE2 (bottom)
FE0–FE1
LEFT, RIGHT/PRIMARY
ISDN S/T
1–0
Example 1.
"Recovering a Lost Password"
Basic Router Configuration
section in Chapter 14,
OL-6426-02