Verify The Configuration; Configuring Shdsl - Cisco 1812W - Integrated Services Router Wireless Configuration Manual

Chapter 4 Configuring PPP over ATM with NAT
If you wish to change any of these settings, use one of the following commands in global configuration
mode.
•
•
•
See the Cisco IOS Wide-Area Networking Command Reference for details of these commands.

Verify the Configuration

You can verify that the configuration is set the way you want using the show dsl interface atm 0
command from privileged EXEC mode.

Configuring SHDSL

Complete the following steps to configure the DSL controller in your router to use SHDSL signaling,
beginning in global configuration mode.
Command
Step 1 controller dsl port
Example:
Router(config)# controller dsl 0
Router(config-controller)#
Step 2 line-term {co | cpe}
Example:
Router(config-controller)# line-term co
Router(config-controller)#
Step 3
exit
Example:
Router(config-controller)# exit
Router(config)#
Step 4 mode protocol
Example:
Router(config)# mode atm
Router(config-controller)#
OL-6426-02
dsl operating-mode (from the ATM interface configuration mode)
dsl lom integer
dsl enable-training-log
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Configure DSL Signaling Protocol
Purpose
Enters the configuration mode for the DSL
controller.
Specifies if the DSL line is terminated at a central
office (CO) or at customer premises equipment
(CPE).
Exits controller configuration mode, returning to
global configuration mode.
Specifies the mode of the DSL controller and
enters controller configuration mode.
4-7