Related Manuals for Ballard Designs Veranda MS100
Summary of Contents for Ballard Designs Veranda MS100
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Veranda Console ITEM NUMBER: MS100 ASSEMBLED DIMENSIONS : 34”H x 58”W x 16”D PRODUCTS ARE NOT INTENDED MADE IN CHINA FOR COMMERCIAL USE. UPDATED: 9/30/2019 Page 1 of 4...
- Page 2 NOTE: Assemble console in location for use. Shelves Hardware Packet TOOLS NEEDED: Ltr. Qty. Hardware Included Phillips Screwdriver -Two person assembly suggested. Shelf Supports Remove all parts, hardware and Wall Anchoring protective packaging from carton Hardware Kit and carefully arrange on a clean, (Anti-Tip) level, padded surface.
- Page 3 STEP 1: INSTALL SHELVES Determine location for each Shelf (D) then insert Shelf Supports (A) in corresponding pre-drilled holes. Gently tilt then lay Shelf level upon Supports. STEP 2: LEVEL CONSOLE Console is equipped with Rotary Levelers located under each corner. If necessary, Console may be leveled by tilting up and turning Levelers clockwise/counterclockwise until level.
- Page 4 ANCHORING HARDWARE (ANTI-TIP) Ltr. Qty. Hardware Included Small Screw WARNING Large Screw Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Locate and mark a Wall Stud behind unit at location for installation. 2.
Need help?
Do you have a question about the Veranda MS100 and is the answer not in the manual?
Questions and answers