Related Manuals for Ballard Designs Ananda MS114
Summary of Contents for Ballard Designs Ananda MS114
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Ananda Serving Table ITEM NUMBER: MS114 ASSEMBLED DIMENSIONS : 33”H x 81 1/2”W x 12”D PRODUCTS ARE NOT INTENDED MADE IN CHINA FOR COMMERCIAL USE. UPDATED: 12-15-2020 Page 1 of 4...
- Page 2 Assemble in location for intended use. REQUIRED TOOLS: Phillips Screwdriver, Ltr. Qty. Hardware Included Allen Wrench (included) Allen Bolts -Two person assembly suggested. Remove all parts, hardware and Flat Washers protective packaging from carton and carefully arrange on a clean, Allen Wrench level, padded surface.
- Page 3 STEP 1: Invert Top (E) onto a clean, soft, level surface then insert Brackets (G,H) as illustrated below. NOTE: Brackets #1 and #2 must be installed opposite one another on the same end. STEP 2: Carefully align each Leg (F) between Brackets (G,H) then attach by inserting Allen Bolt (A) with Flat Washer (B) and firmly tightening using Allen Wrench (C).
- Page 4 WALL ANCHORING HARDWARE (ANTI-TIP) Ltr. Qty. Hardware Included Large Screw Small Screw WARNING Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit. 2.