Advertisement
Quick Links
PRODUCT NAME: Abilene Console
ITEM NUMBER: MS162
ASSEMBLED DIMENSIONS : 33"H x 41"W x 18 1/2"D
LEGS: Set Console (B) onto its back. Insert,
turn and tighten Legs (A) into each corner.
Set upright.
1
(B)
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-12-2024
NO TOOLS REQUIRED
ASSEMBLED WEIGHT: 121 lbs.
ASSEMBLY TIME: Less than 5 minutes
Ltr.
Qty.
Hardware/Components Included
4
A
1
B
2
C
LEVELERS: Each Leg (A) is equipped with a
Rotary Leveler. To adjust, lift applicable corner
and turn Leveler clockwise/counter-clockwise.
2
(A)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Legs
Console
Wall Anchoring
(Anti-tip) Kits
See page 2
NOTE
Set furniture into place and level
before anchoring to wall.
FULLY REMOVING DRAWERS
Drawers feature undermount metal glides.
First, fully open/extend drawer then reach under
each front corner and pull latches to release
drawer from glides.
Lift drawer up and out.
Latches (front corners)
Drawer Underside
MADE IN VIETNAM
Page 1 of 2
Advertisement
Related Manuals for Ballard Designs Abilene MS162
Summary of Contents for Ballard Designs Abilene MS162
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Abilene Console ITEM NUMBER: MS162 ASSEMBLED DIMENSIONS : 33”H x 41”W x 18 1/2”D NO TOOLS REQUIRED ASSEMBLED WEIGHT: 121 lbs. ASSEMBLY TIME: Less than 5 minutes Ltr. Qty. Hardware/Components Included Legs Console Wall Anchoring (Anti-tip) Kits See page 2...
- Page 2 WALL ANCHORING HARDWARE (ANTI-TIP) Ltr. Qty. Hardware Included Large Screw Small Screw WARNING Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit. 2.
Need help?
Do you have a question about the Abilene MS162 and is the answer not in the manual?
Questions and answers