Sweden; Power Supply Requirements; For Use In Norway; Power Cord Set Requirements - HP ap5000 - All-in-One Point of Sale System Safety And Regulatory Information Manual

Safety and regulatory information hp ap5000 all-in-one point of sale system
Hide thumbs Also See for ap5000 - All-in-One Point of Sale System:
Table of Contents

Advertisement

Sweden

Apparaten skall anslutas till jordat uttag, när den ansluts till ett nätverk.

Power Supply Requirements

The power supplies on some products have external power switches. The voltage select switch feature
on the product permits it to operate from any line voltage between 100-127 or 200-240 volts AC. Power
supplies on those products that do not have external power switches are equipped with internal circuits
that sense the incoming voltage and automatically switch to the proper voltage.
For safety reasons, use only the AC adapter provided with the unit or an authorized replacement adapter
from Hewlett-Packard. Replacement part numbers may be found at
hpsupport/index.pl.

For Use in Norway

This product is also designed for an IT power system with phase-to-phase voltage 230V.

Power Cord Set Requirements

The power cord set received with the product meets the requirements for use in the country where you
purchased the equipment. Use only the power cord provided with the unit or an authorized replacement
power cord from Hewlett-Packard or an approved HP source. Replacement part numbers may be found
at http://www.hp.com/cgi-bin/hpsupport/index.pl.
Power cord sets for use in other countries must meet the requirements of the country where you use
the product. For more information on power cord set requirements, contact your authorized HP dealer,
reseller, or service provider.
WARNING!
Mismatched power cords may result in a shock and fire hazard.
The requirements listed below are applicable to all countries:
1.
The power cord must be approved by an acceptable accredited agency responsible for evaluation
in the country where the power cord set will be installed.
2.
The length of the power cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). For a power cord
2.0 m (6.56 feet) or less, the diameter of the wire must be a minimum of 0.75 mm
the power cord is longer than 2.0 m (6.56 feet), the diameter of the wire must be a minimum of
1.0 mm
The power cord should be routed so that it is not likely to be walked on or pinched by items placed upon
it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the
cord exits from the product.
WARNING!
damaged in any manner, replace it immediately. Damaged cords may result in user exposure to hazards.

Japanese Power Cord Requirements

For use in Japan, use only the power cord received with this product.
CAUTION:
ENWW
Do not use power cords from other products.
2
or 16AWG.
Do not operate this product with a damaged power cord set. If the power cord set is
Do not use the power cord received with this product on any other products.
http://www.hp.com/cgi-bin/
Power Supply and Power Cord Set Requirements
2
or 18AWG. If
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents