Copying Still Images From A Pc To The Camera - Toshiba Gigashot GSC-R60 Owner's Manual

Copying Still Images from a PC to the Camera

Use this procedure to copy images saved on a PC to the camera's hard disk drive.
IMPORTANT
• With a "FULL SPEED MODE" connection, this function cannot be used because
the camera is protected. Check the connection settings and your PC.
Turn on the PC and the camera.
1
Select USB mode.
The gigashot backup tool starts up.
See "Connecting to a PC"
2
Click [View data using ACDSee].
ACDSee starts up.
3
Select the images you want to copy to the camera and
click [Copy to Camera] in the [Create] menu.
4
Select the image conversion size and click [OK].
The sizes of the resized images vary depending on the source image size.
Images larger than 640 ✕ 480
Images are resized to 1024 ✕ 768. Where the original image is smaller than
1024 ✕ 768, a black border appears around the image.
Images smaller than 640 ✕ 480
Images are resized to 640 ✕ 480. Where the original image is smaller than
640 ✕ 480, a black border appears around the image.
MEMO
• If you select "Do not resize", you may not be able to view some image sizes
correctly on the camera.
• You may be unable to display copied images that were not shot on this camera.
p.150.
The images are copied to the camera's hard disk
drive and stored in the "XXXACDSE" folder under
file names in the "ACDSXXXX.jpg" format.
Copies all the images at 640 × 480 pixels,
regardless of the original image size.
Copies images as is without resizing.