Page 17
(inch) (lb) mm (inch) kg (lb) 510 mm 570 mm 650 mm 750 mm (29½”) (20”) (22½”) (25½”) Overall width 750 mm 920 mm 1110 mm 1110 mm (29½”) (36¼”) (43¾”) (43¾”) Length 460–570 mm 530–640 mm 680–790 mm 880–990 mm (18–22½”) (20¾–25¼”) (26¾–31”)
Page 20
ENGLISH General We appreciate your choice of a new product from R82 - a worldwide supplier of technical aids and ap- pliances for children and teenagers with special needs. To fully benefit from the options offered by this product please read this User Guide before use and save it for future reference. Intended purpose •...
Page 21
Spare parts can be ordered on request. Find the specific accessories on our website or contact your local dealer for further information. R82 Warranty www.etac.com/support Presales information and instructions Presales information and instructions are available at www.etac.com, under your product, in the documents section.
Page 22
Safety Signs, symbols and instructions placed on this product must never be covered or removed and must remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions. Any adverse event in relation to the device must be reported to your local dealer and the national com- petent authority in a timely manner.
Page 23
vehicle by a lift • Unoccupied device is suitable for land and air transport • Details covering EMC can be found in the appendix "EMC details" supplied with the product...
Page 24
Service & maintenance information Service and maintenance of a medical device is wholly the responsibility of the owner of that device. Failure to service and maintain a device in accordance with the instructions may invalidate the device’s warranty. Furthermore, failure to service and maintain a device may compromise the clinical condition or safety of users and/or their caregivers.
Page 25
• Rubber • Polyurethan Surface treatment The following surface treatment processes were used to protect against corrosion: • Lacquered surfaces = Polyester powder coating or ED-coating • Non-lacquered aluminium parts = Anodized coating • Non-lacquered steel surfaces = Galvanized Power unit For an optimum lifetime the power unit must be connected to the mains voltages as often as possible (e.g.
Page 26
Technical Data Battery - BA18 HB40 • Capacity 1.3 Ah - 24V DC • Charging current is max. 500 mA • IPX6 The batteries have a maximum life of 4 years but this can vary depending upon the conditions of use and charging practices BA18 Battery charger - CH01...
Need help?
Do you have a question about the R82 Caribou and is the answer not in the manual?
Questions and answers